Announcement

Collapse
No announcement yet.

Official "How Does This Fit?" Thread

Collapse
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • bassoonguy
    replied
    i just bought a new jcrew ludlow suit and I am having an issue with the shoulder kind of rolling and not laying flat. Is this a fit issue or is it from shipping and will steam out? I've never seen this before.

    https://drive.google.com/drive/folde...qr?usp=sharing

    Leave a comment:


  • facelessghost
    replied
    Originally posted by JBarwick View Post
    Jacket is way too short at least from the front. It should cover your butt which usually occurs around the 2nd knuckle on your index finger. Based on your picture, the jacket doesn't even touch the base of your fingers.
    I second this.

    Leave a comment:


  • JohnR
    replied
    Originally posted by Tacitus View Post
    Unfortunately, I did not - should have. I tried the finger-curling test, and it came up a little short - basically ends at the top thumb knuckle (where the thumb is joined to the palm) rather than the middle thumb knuckle.

    Basically 0.5-1 inches shorter than Ron and Dgamby's pictures above - if it were an inch longer I wouldn't be worried at all
    Looks fine from here and I wouldn't trust the finger-curl test, anyway. I'd be more interested in where the bottom of the jacket is relative to your zipper. Assuming you're average height and wearing properly fitted pants, the jacket should be about halfway down the zipper, perhaps a bit lower if you're a tall guy.

    Leave a comment:


  • JBarwick
    replied
    Originally posted by Tacitus View Post
    Unfortunately, I did not - should have. I tried the finger-curling test, and it came up a little short - basically ends at the top thumb knuckle (where the thumb is joined to the palm) rather than the middle thumb knuckle.

    Basically 0.5-1 inches shorter than Ron and Dgamby's pictures above - if it were an inch longer I wouldn't be worried at all
    Jacket is way too short at least from the front. It should cover your butt which usually occurs around the 2nd knuckle on your index finger. Based on your picture, the jacket doesn't even touch the base of your fingers.

    Leave a comment:


  • Tacitus
    replied
    Unfortunately, I did not - should have. I tried the finger-curling test, and it came up a little short - basically ends at the top thumb knuckle (where the thumb is joined to the palm) rather than the middle thumb knuckle.

    Basically 0.5-1 inches shorter than Ron and Dgamby's pictures above - if it were an inch longer I wouldn't be worried at all

    Leave a comment:


  • ianr
    replied
    Originally posted by Tacitus View Post
    With the caveat that it's getting pulled up a little by the arm that's holding the phone - is this jacket too short?
    Looks okay to me. Did you happen to take a picture without your arm raised?

    Leave a comment:


  • Tacitus
    replied
    With the caveat that it's getting pulled up a little by the arm that's holding the phone - is this jacket too short?

    Leave a comment:


  • JohnR
    replied
    Originally posted by dgamby View Post
    That's helpful. I had a bad experience with my last tailor and will likely be looking for a new one. Probably will start off with something smaller than removing the sleeve when I try out a new tailor. I may get some work done on these down the road but wanted to make sure that they were passable as is.
    They are. I don't think many people pay attention to fit as much as we do. I have a really great tailor and would always recommend finding one, yourself. Not many things fit me well off the rack so that was important for me. I can get away with wearing things OTR enough of the time but the difference that my tailor can make is very noticeable to me and worth it for a lot of what I wear. And if he doesn't think he can improve something enough for me to spend the money on it, he'll tell me so. I think it's worth some time on Yelp and shopping around, if you have the inclination.

    Leave a comment:


  • dgamby
    replied
    Originally posted by JohnR View Post
    They don't look way off but the shoulders could be improved a tad. If I paid 50 for a coat, I'd take some of the savings and have my tailor fit it perfectly for me (you can make something that was very affordable look like it's a million bucks with good tailoring). But if you didn't, I don't think anyone would say they're poorly fit as is.
    That's helpful. I had a bad experience with my last tailor and will likely be looking for a new one. Probably will start off with something smaller than removing the sleeve when I try out a new tailor. I may get some work done on these down the road but wanted to make sure that they were passable as is.

    Leave a comment:


  • JohnR
    replied
    Originally posted by dgamby View Post
    Thanks for the input. They were 50 each so I probably won't spend the money to have any major tailoring done. Might shorten the sleeves a hair. I just wanted to make sure they didn't look off.
    They don't look way off but the shoulders could be improved a tad. If I paid 50 for a coat, I'd take some of the savings and have my tailor fit it perfectly for me (you can make something that was very affordable look like it's a million bucks with good tailoring). But if you didn't, I don't think anyone would say they're poorly fit as is.

    Leave a comment:


  • dgamby
    replied
    Originally posted by JBarwick View Post
    [MENTION=21689]dgamby[/MENTION] - In the first brown SC pic, your right shoulder has a slight divot. I have this as well and it doesn't bother me too much. I think this can be fixed by adjusting the sleeve pitch so if you want to spend $50 and have a competent tailor, they can remove the arm and reattached at a better angle to fix.

    But I think both look fine as is. You could slightly fix the back from the wrinkles with tailoring but it is up to you.
    Thanks for the input. They were 50 each so I probably won't spend the money to have any major tailoring done. Might shorten the sleeves a hair. I just wanted to make sure they didn't look off.

    Leave a comment:


  • JBarwick
    replied
    [MENTION=21689]dgamby[/MENTION] - In the first brown SC pic, your right shoulder has a slight divot. I have this as well and it doesn't bother me too much. I think this can be fixed by adjusting the sleeve pitch so if you want to spend $50 and have a competent tailor, they can remove the arm and reattached at a better angle to fix.

    But I think both look fine as is. You could slightly fix the back from the wrinkles with tailoring but it is up to you.

    Leave a comment:


  • Ron
    replied
    Originally posted by thedrake View Post
    You're right the front does look pretty good. Can you take it to a tailor and get their opinion on if there's anything they can do about the back?
    Thanks for replying.

    Yes I guess I could visit the tailor. I started looking online and I saw several videos where creases can be corrected. The ones I saw were symmetrical but I am sure the process is similar.

    Leave a comment:


  • dgamby
    replied
    I have two blazers I'm trying to decide on keeping or returning. I'm most curious about if the shoulders fit right. I've read that's the most important thing to fit well and can't tell if it looks a little funny because of the padding there or if the fit is wrong. Any advice is appreciated!





    Leave a comment:


  • thedrake
    replied
    You're right the front does look pretty good. Can you take it to a tailor and get their opinion on if there's anything they can do about the back?

    Leave a comment:

Working...
X